Baumatic BCE6001, Инструкция по эксплуатации, Страница: 17 / 24

o
IMPORTANT: There are ventilation holes around
the outside of the cooktop. YOU MUST ensure
that these holes are not blocked by the work
top, when you put the cooktop into position
(see drawing opposite).
o
NOTE: Your appliance comes fitted with a sealing
strip already attached to the underside of the
cooktop. This should not be removed as it will
prevent liquid or spillages from penetrating the
underneath of the cooktop.
o
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the
cooktop from the aperture in future, particularly if it needs to be
serviced.
o
Carefully lower it into the aperture hole that you have cut out.
(A) Clamp
(B) Screw
(C) Sealing strip
o
Place the clamp (A) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
cooktop. Slightly tighten a screw (B) through the clamp (A) so
that the clamp is attached to the cooktop, but so that you can
still adjust the position of it.
o
On the underneath of the cooktop, adjust the clamps into a
position that is suitable for your worktop. Then fully tighten the
screws (B) to secure the cooktop into position.
16