13
7.2 Before Locating the Fixing Brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto the
controls protruding from the hob.
Fix the hob on the work surface by screwing the four brackets on the bottom of the hob (see picture) after
installation.
A
B
C
D
screw bracket Screw hole base
Adjust the bracket position to suit for different work surface’s thickness.
7.3 Cautions
1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals
at your service. Please never conduct the operation by yourself.
2. The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The ceramic cooker hob shall be installed such that better heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
7. Using a silicon sealant to seal the appliance against the aperture can make removal difficult and may
void the warranty.
7.4 Connecting the Hob to the Mains Power Supply
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit
breaker. The method of connection is shown below.
HOB
BLACKET
TABLE
A
HOB
BLACKET
TABLE
B
