Baumatic AS35SS, Инструкция по эксплуатации

Страница: 20 / 25

For installation with a chimney. (Figure 5)
• For ease of mounting, trace a central line on the wall (1). Position
the cut-out template, so that the middle line printed on the top of it,
corresponds to the central line that you have marked previously.
The bottom of the template should correspond to the lower part of
the hood, once it is mounted (2).
• Drill two holes Ø 8 mm and fasten the support bracket „F“ with
two wall inserts and screws (3).
• Mount the hood (5) onto support bracket „F“. You can then level
the appliance using the adjusting brackets (6 and 7).
• Lift the cover screen and mark the lower fixing point on the wall
(10). Remove the hood and drill on this marking, one hole of Ø 8
mm (9). Then insert one wall plug, hang the hood again and fasten
it securely with one screw (11).
CONNECTING THE CHIMNEY SECTION (FIGURE 6).
• Apply the support bracket „G“ to the
wall. Using the chimney support bracket as a
guide, you should mark two holes with a
pencil and then drill out these holes with an
8mm drill bit. Then insert two raw plugs. The
small indentation found in the middle of the
support bracket should coincide with the
centre line previously marked on the wall.
• Fasten the support bracket „G“ to the
wall with two 5 x 45mm screws (4).
•
When fitting this appliance with a
chimney section, it is possible to use the
product in recirculation mode. However it is
obligatory to fit a carbon filter (see page 12
for details on how to fit the carbon filter). If
you are going to use the appliance
in extractor mode, please see page 20.
19