7
SPREADING MATERIAL
REGULATING SPREAD QUANTITY
The spreading quantity is adjusted with the tension adjustment lever. Correct adjustment is
important. If the adjustment is too tight, unnecessary wear of the rubber belts or rotating parts may
occur. If the adjustment is too slack, distribution of material will be uneven.
Hydraulic Units:
All hydraulic units are equipped with hydraulic flow control. To ensure to correct
rate of drop of material, the operator would adjust the tension adjustment lever, hydraulic flow
control, engine RPM, and ground speed. Adjusting engine RPM impacts hydraulic flow.
PTO Units:
To ensure the correct rate of drop of material, the operator would adjust the tension
adjustment lever, engine RPM, and ground speed.
STARTING TO SPREAD
S
preading of material starts as soon as the tractor’s PTO, hydraulic, or electrical system is engaged.
HYDRAULIC ROUTING INSTRUCTIONS
Hydraulic:
The hydraulic spreader models come equipped with the hoses and fittings already
installed in their intended orientation. Ensure the tractor hoses are attached in such a way that
allows for the agitator and distributor drum to rotate in the direction shown in Figure A. A decal
depicting the correct rotation direction has also been positioned near the bearings supporting these
shafts.
Figure A:
Direction of Drum
Rotation
Содержание 640H
