Baumalight MX530, Руководство оператора, Страница: 24 / 32

6 SERVICE And MAINTENANCE
6.1 Maintenance
Maintenance Chart
General Inspection Inspect the unit for any buildup of contamination
(dirt, stones, etc.).
Daily
Cutting Teeth Check and replace one at a time as necessary.
With daily use expect to replace 4 to 6 teeth per
day. See Replace Cutting Teeth in this section.
Every 4 hours.
Drive Belt Check belt tension, alignment and inspect belt
for wear or damage. Replace damaged or worn
belt.
Every week.
Rotor Bearings Check bearings for side-to-side and up/down
movement. Replace bearings if movement is
found.
Every week.
6.2 Inspection
^
WARNING
Prevent serious injury or death caused
by unexpected movement:
1�
Park excavator on a level surface�
2�
Engage excavator park brake�
3�
Disengage hydraulic drive�
4�
Shut off engine and remove key�
^
WARNING
Clean machine thoroughly before
service or maintenance procedures�
The health effects from exposure to
wood dust are due to chemicals in the
wood or chemical substances in the
wood created by bacteria, fungi, or
molds�
Inspect the unit for any buildup of contamination
(dirt, stones, etc.).
Check cutting teeth every 4 hours of use. Keep
cutting teeth in good condition. Unit will cut faster
and remaining teeth will last longer if broken or
worn teeth are replaced.
22