5�3 Rotate Cutting Teeth - DPH530
Check cutting teeth every 4 hours of use. Keep
cutting teeth in good condition. Unit will cut faster
and remaining teeth will last longer if broken or
worn teeth are replaced.
Each tooth can be rotated two times from its
original position before replacement is necessary.
1. Park tree saw on a level surface.
2. Lower blade to the ground.
3. Shut off engine and lockout engine controls.
4. Inspect teeth for wear on outside edge. Once
outside edge is worn, rotate tooth so a new
edge is on outside (cutting) edge.
5. Loosen locknut (A) on tooth (B) and rotate
tooth 1/3 turn. Flat shoulder on tooth will fit
against shoulder (C) on tooth holder.
6. Tighten locknut (A) to 65 lb/
ft (88 Nm) of torque.
A
B
C
Note
:
Parts breakdown can be found on
Baumalight’s website. www.baumalight.com
5�4 Replace Cutting Teeth - DPH530
1. Park tree saw on a level surface.
2. Lower blade to the ground.
3. Shut off engine and lockout engine controls.
4. Inspect cutting teeth (B) for damage and wear.
Replace individual teeth as needed.
5. Remove locknut (A) and tooth (B). Install new
tooth. Flat shoulder on tooth will fit against
shoulder (C) on tooth holder.
6. Install locknut. Tighten locknut (A) to 65 lb/ft
(88 Nm) of torque.
A
B
C
Note
:
Parts breakdown can be found on
Baumalight’s website. www.baumalight.com
17
