PAGE 8 TP10583
1.1
INSTALL
FEED
TABLE
See
Figure 4.
Place feed table with feed wheel toward
the rolls. Slide the front knotch onto locating pins
(1)
and
rotate the back end of the table downward to rest on upper
dowel pins (2). Identical pins on both frames.
Rotate the handwheel to make sure the gears mesh.
Identify cable connected to the bottom of the feed table.
Engage the other end of this cable to the mating circular din
connector mounted in front frame. Turn rotating collar CW to
lock in place.
1.2 I
NSTALL
BOTH
FOLD
PANS
The fold pans are identical.
See
Figure 5
for positioning:
Pan 1 sets on pins
1 and 2
Pan 2 sets on pins
5 and 6
Rubber hold downs
3 and 7
Pan 1's mating connector is
4
Pan 2's mating connector is
8
Insert one pan into pan 1 position. With motor end of
pan towards the person installing the pan, angle front end
down and set onto locating pins
(1).
Rotate back end down
until center knotch is seated onto second set of locating pins
(2).
Two rubber hold downs on top of the pan now need to
be rotated into position to hold the pan
(3).
Locate a cable
attached to the back end of the pan and engage the opposite
end into the mating circular din connector near the top of
the front frame
(4).
Rotate this collar CW to lock in place.
Repeat for pan 2 execept angle front end of this pan
upward. Engage its cable connector into mating connector
about half way down the left edge of the front frame
(8)
.
Figure 4
1 2
Figure 5
1
2
3
4
5
6
7
8
M
ANUALLY
TURN
THE
HAND
WHEEL
AFTER
INSTALLING
BOTH
PANS
TO
MAKE
SURE
NEITHER
PAN
IS
RUBBING
AGAINST
THE
ROLLS
.
