Baukraft BK-SGC10 SET, Руководство пользователя

Страница: 17 / 90

17
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such
as the times when the tool is switched off and when it is running idle in addition to the trigger time).
III. Use.
1. Preparing the Coating Material
The paints usually need to be diluted for use with the spray gun. Since information on sprayable
dilutions is seldom given on the material tin, you can use the guidelines in the viscosity table on the
following page (viscosity = consistency of the coating material).
Measuring the Viscosity.
Stir the coating material thoroughly before measuring.
Dip the viscosity test cup completely into the coating material.
Hold the test cup up and measure the time in seconds until the liquid empties out.
Note: This time is called “Runout Time in Seconds”.
Viscosity table
Material Run out Time (Sec)
1) Oil enamel 25-60
2) Oil based primer 30-60
3) Oil stain No thinning required
4) Clear sealer No thinning required
5) Polyurethane No thinning required
6) Varnish 20-60
7) Lacquer sanding sealer 25-35
8) Lacquer 25-35
9) Automotive finishes 20-40
10) Latex 45-90
2.Install the air hose. Insert the air hose tightly into the machine and gun connections.
3. Unscrew the container from the gun.
4. Adjust the suction pipe. The contents of the tank must be used almost completely. When painting
horizontal surfaces, turn the suction tube forward. When painting ceilings, turn the suction pipe to
the back of the tank.
5. Place the tank on a sheet of paper to prevent contamination from dripping. Pour the prepared
paint and wrap tightly.
6. Leave the machine on a flat, clean surface. Otherwise, the machine may suck up dust and more.
7. Remove the pistol from the stand and aim it at the object.
8. Turn on the trigger switch and point the gun at the surface to be painted.
IV. Spray Technique.
The spray result depends heavily on the smoothness and cleanliness of the surface to be sprayed.
Therefore the surface should be carefully prepared and kept free of dust. Cover all surfaces not to be
sprayed. Cover screw threads or similar parts of the target object. It is advisable to test the spray gun
on cardboard or a similar surface to find the correct setting. Important: Begin spraying outside of the
target area and avoid interruptions inside the target area. An even movement of the spray gun results
in an even surface quality.