BAUKER CDT212W, Оригинальное руководство пользователя

Страница: 14 / 20

EN-14
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for driving in and loosening screws as well as for drilling in wood, metal and
plastic.
BEFORE PUTTING INTO OPERATION
1. RECHARGING BATTERIES
a) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may become too hot. Allow time for the
battery to cool down before recharging.
WARNING!
Do not continue to press the On/Off switch after the tool has been automatically switched off. The battery
can be damaged.
b) IMPORTANT NOTES FOR CHARGING THE BATTERY
The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged
before using the first time
NOTE: If the battery pack is very hot you must remove your battery pack from the charger and allow your
battery pack to cool first to ambient temperature and then recharging can be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery to reach full or
no less than half charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6
months
c) CHARGING (SEE FIG. A)
1) Plug the charger into an appropriate outlet. The light (a) will be green.
2) Insert the Battery Pack (4) into the charger, the light (b) will be red to indicate the charging process
has started.
3) On completion of charge, the light (a) is green, and light (b) will be off. The pack is now fully
charged, unplug the charger and remove the battery pack.
WARNING:
When battery charge runs out after continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool down before re-charging to achieve
the full charge.
2. REMOVE OR INSERT BATTERY PACK (SEE FIG. B)
Press the battery pack release button and remove the battery pack from the tool. After recharge slide the
battery pack into tool’s battery port. A simple push and slight pressure will be sufficient.