BAUKER BTC180B, Оригинальное руководство пользователя

Страница: 12 / 16

EN-12
WARNING:
Please perform an RCD test before using your tool and follow the above instruction.
If the RCD repeatedly is power off with an appliance connected or if it fails to power off when
tested following the above instructions, please do not use the RCD and you must seek advice from a
qualified electrician.
1. ON/OFF OPERATION WITH RCD SWITCH
Connect the plug to the power supply, press the RESET button, the pilot lamp turns red.
The blade can be operated by pressing the “I” on switch.
Before you begin cutting, the blade must achieve the max. speed.
To stop the tool, you must press “O” on the switch.
2. ON/OFF OPERATION WITHOUT RCD SWITCH (See G)
Connect the plug to the power supply. The blade can be operated by pressing the “I” on switch.
Before you begin cutting, the blade must achieve the max. speed.
To stop the tool, you must press “O” on the switch.
3. FITTING THE WATER TRAY (SEE H)
Before the cutter can be used, the water tray must be filled.
To remove the tray, slide it outwards until it comes into contact with the blade housing. Lift the tray side
of the machine until the tray can be removed completely. Fill the tray to 3/4 full with water. Do not add
chemicals or detergents to the water. Insert the tray in the opposite manner to removal.
4. SECURING THE TILE CUTTER
The tool can be secured to a workbench by using 3 suitable screws (Not provided) through two lugs and
the hole in the frame.
5. MAKING A STRAIGHT CUT
Adjust the parallel guide to the desired width from the blade using the scale rules on the table surface
for reference. Loosen and adjust the two securing knobs. (See E)
Position the tile firmly against the parallel guide and pass through the blade in a smooth action. Do not
force the tile to be cut too quickly. (See I)
6. MAKING A MITER CUT (SEE J)
Follow the same procedure for a straight cut but employ the miter guide in conjunction with the parallel
side fence. The miter guide simply runs up against the edge of the parallel side fence.
Ensure that the tile is held firmly into the guide before making the cut.
7. CUTTING WITH THE TABLE AT AN ANGLE (SEE K)
Use this facility if you wish to cut an angle on the tile cutter.
Loosen the two table securing knobs (one at each side of table).
Tilt the table to the desired angle using the scale on the table.
Re-secure the table and make the cut as before.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.