Manual for
BAUER RAINSTAR A3
28
13 SPEEDOMETER
Programming the Computer
CHOOSE MILES OR KILOMETERS
The A4 allows to display the speed and the distance in kilometers or miles. You may always change between
these units whereby all values will be converted automatically.
STEP 1
Open „TRP“ on the display. Keep the SET key pressed for approximately 3 seconds.
STEP 2
km or m is blinking on the right top of the display. Change to "
km
" by means of the MODE key.
STEP 3
Press the SET key to confirm your selection. Now A4 changes automatically to the setting mode for the
radius factor.
PROGRAMMING THE RADIUS FACTOR
After selecting the unit – m or km – and pressing the SET key for confirmation, the computer changes
automatically to the setting mode for the radius factor. Factory setting is 2155 mm and/or 84.8 inches.
STEP 1
Set the blinking figure by means of the MODE key.
Radius factor with kilometers „
728
„
STEP 2
Confirm the setting by means of the SET key. ===> The next figure is blinking.
STEP 3
Repeat the setting until all figures are set correctly.
STEP 4
Press the SET key for approximately 3 seconds in order to finish the setting procedure and to return to
the TRP display.
SETTING THE TIME
The VDO A4 has got a 24 hours time display.
STEP 1
Press the SET key in CLK mode for 3 seconds. Now your computer changes automatically to the time
setting mode.
STEP 2
Set the blinking hours by means of the MODE key. Confirm your setting by means of the SET key.
===> The minute figures are blinking.
STEP 3
Set the blinking minutes by means of the MODE key. (Keep the key pressed for fast run).
STEP 4
Keep the SET key pressed for approx. 3 seconds in order to finish the setting procedure and to return
to the CLK display.
