Page 15
For technical questions, please call 1-888-866-5797.
Item 57179
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
10. With narrow material, press down lightly to
cut the workpiece. Press straight down,
“chopping” the material. Do not bear down on
the material — use light downward pressure.
If the material binds the blade, release the Trigger.
11. With wide material, move the Blade across
the workpiece while cutting as follows:
a. Loosen Slide Lock Knob and pull
Saw Head Assembly forward.
b. Press down on the Saw Handle.
c. Push the Saw Head toward the rear to
make the cut. Refer to Figure I.
Do not bear down on the material — use light
downward and lateral pressure. If the material
binds the blade, release the Trigger.
12. When the cut is completed, raise the Saw
Head, release the Trigger, wait for the Blade
to stop turning, release the Clamp and
remove the workpiece from the Saw.
13. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
Workpiece
Workpiece
pull Forward
1
press
Down
2
Slide Lock
Slide Lock
Knob
Knob
push toward rear to cut
3
Figure i
14. Lock the Saw Head down and lock all other
adjustments before moving the Saw. Use the
Carrying Handle and handle cut outs on each side of
the Base to lift and support the Saw while moving it.
cutting Operations
cross cut
Miter cut
Bevel cut
compound cut
