Page 12
For technical questions, please call 1-888-866-5797.
Item 58862
SA
FE
TY
OP
ERA
TI
O
N
MAINT
ENANC
E
SE
TUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
BEFORE EACH USE,
inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2.
AFTER USE,
turn off the tool, remove
the Safety Key from the Switch, and
disconnect its power supply. Wipe external
surfaces of the tool with clean cloth.
3. A Dust Port is located on the bottom of the
Lower Guard Plate. It is held in place with a
Screw and can be removed for vacuuming
collected dust and sanding residue. Replace the
Dust Port after cleaning and tighten Screw.
4. Apply a light coat of paste wax to the Table
to make feeding material easier.
5. Use compressed air to blow dust and
debris from the Sander and Motor.
6. The Bearings on this Sander are sealed
and do not require lubrication.
7.
WARNING! TO PREVENT SERIOUS
INJURY: If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
