Page 8
For technical questions, please call 1-888-866-5797.
Item 64755
SA
FE
TY
OP
ERA
TI
O
N
MAINT
ENANC
E
SE
TUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and remove its Battery
Pack before performing any procedure in this section.
Batter Charging
Charge battery after unpacking and before using this tool. Follow instructions included with battery charger.
Attaching/Removing Accessories
CAUTION!
Only use 1/4" hex shank bits
designed for impact use. Verify bit fits
the Chuck precisely before use.
1. Pull Collar forward and insert an appropriate
impact-rated accessory into the hex drive Chuck.
Pull on bit to ensure it is secure.
2. To remove, pull Collar forward, remove bit
from Chuck and then release Collar.
Collar
Attaching Belt Clip
Attach Belt Clip to Handle using supplied Screw.
Clip may be attached to either side.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Screw
Belt Clip
