Magicvapor
13
2016
1.
Run the iron on garments, pressing the iron micro-switch for steam and the
vacuum pedal at the same time (fig. 1). We suggest you to press the pedal a bit
longer than the micro-switch in order to dry the garment.
2.
For delicate, black and blue garments, we advise you to use the anti-sheen shoe.
3.
During ironing, always put the iron on its rubber rest (fig. 1).
4.
For dry ironing it is possible to adjust the thermostat (fig. 4) on different positions
according to the type of fabric (look at garment label). For steam ironing, set the
thermostat on “cotton” or “linen”.
7.
WATER FILLING
During the ironing, if steam flux decreases considerably
and then ends completely, it means that there is no more
water in the boiler.
Unplug the machine, unscrew the safety valve plug just
slightly 360° (fig. 3) so that all the steam comes out.
Completely unscrew the valve plug with care and wait at
least 5/10 minutes. Then fill the boiler (fig. 6) with water
making sure not to exceed MAX level (section 4.1). Screw
the valve plug again (fig. 1), turn on the machine and wait
for the boiler lamp to switch off (fig. 2 A). Now the iron is
ready again.
While refilling the boiler, do not spill water onto the machine.
In the event his should happen, dry immediately in order
to avoid electrical risks.
8.
BOILER DISCHARGE
Empty the boiler periodically. Carry out this operation only when the machine is
unplugged and cold. Wait for at least 1 hour after it has been switched off. Wear
proper gloves in order to avoid accidental burns.
Unscrew the valve plug and open the discharge tap (fig. 1), wait for all the water to
come out and then close the tap again. The tap might get clogged: in this case use a
wire with a diameter of 3-4 mm to unclog it.
ELECTRIC
WIRE
THERMOSTAT
MICROSWITCH
FOR IRON
STEAM
HOSE
Fig. 5
Fig. 4
Fig. 6
