Battipav elite 80 9000, Руководство по эксплуатации

Страница: 20 / 23

31
Battipav srl GB
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES
WE RECOMMEND THE USE Of PROTECTIVE
GLOVES AGAINST MECHANICAL RISKS EN388
COMPLIANT WITH DEGREE 4 Of RESISTANCE TO
ABRASION AND CUTTING
ALWAYS STAY IN THE WORKING POSITION (Pos.
1 picture 13) DURING THE MACHINE OPERATION
PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.
MAINTENANCE
CAUTION
BEfORE PERfORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE fROM
THE SUPPLY MAINS.
CLEANING
CAUTION
DO NOT WASH THE MACHINE WITH HIGH
PRESSURE WATER JETS
Through the tap located on the bottom of the
recovery tank, remove any working residual from the
machine.
26 27
Clean the sprayer regularly as indicated.
28
Clean the slide guides regularly to remove cutting
residues.
MOTOR HEAD INCLINATION ADJUSTMENT
The head unit is provided with a register for adjusting
the cutting at 90° and the cut at 45°.
In case of incorrect angles over time, proceed as
follows:
1) loosen the register fixing nut with a 13 mm
wrench.
29
2) with a 6 mm Allen wrench, put the register in
the correct position.
3) lock the register again with the fixing nut.
CAUTION
fOR THE CORRECT POSITIONING Of THE
REGISTERS, USE A SQUARE SHOWING THE 45°.
SLIDING CARRIAGE ADJUSTMENT
The sliding carriage is provided with a register for
adjustment.
If any excessive vertical movement of the carriage
should take place, act as follows:
30 1) with a 13 mm wrench and a 6 mm Allen
wrench, loosen the lower wheel supports.
30 2) make the lower wheel support slide on the
adjustment slot until the vertical play is
eliminated.
3) lock the lower wheel support again.
CAUTION
30 IN CASE Of LATERAL MOVEMENTS Of
THE CARRIAGE, TIGHTEN ALL THE WHEEL
SUPPORTS STILL fURTHER.