A
W
B
Objective
Restriction of the work piece
1.1.1 The POS for MCA series positioner can be used welded, cut and grind, it has one table rotate and table angle move, the operator can be apt to
adjust the work piece position fast, enable him to finish the work and keep quality fast.
1.1.2.1 The weight or length of the work piece exceed designing limiting, please look at charts [Figure:1.2-1].
1.1.2 Forbid using the case:
1.1.2.2 The work piece does not have certain locking in table of EVPOS for MCA series positioner.
1.1.2.3 The scope of activities of the work piece has personnel or hinders things.
1.1.2.4 Have not imputed the machine to the ground or firm foundation.
Figure: 1.2-2
1.1
1.2
1.2.1 CAPABILITY
Page 1
0
200
400
600
800
1000
1200
1400
1600
0
20
40
60
80
100
120
140
0
200
400
600
800
1000
1200
30
40
50
60
70
80
90
100
EVPOS-1TACA
Positioner Eccentric Load
A : Eccentric Center (cm.)
W : Load (kg.)
EVPOS-1TACA
Center of Gravity
B : Center of Gravity (cm.)
W : Load (kg.)
Содержание EVPOS-1TACA
