Batco 1300 P Series, Руководство по эксплуатации

Страница: 29 / 44

BATCO - T
OP
D
RIVE
F
IELD
L
OADER
8. M
AINTENANCE
1300 P, 1500 P S
ERIES
8.1. M
AINTENANCE
S
CHEDULE
P1512121 27
8. Maintenance
8.1. MAINTENANCE SCHEDULE
8.1.1. I
NITIAL START
-
UP SERVICING
Since the belt alignment is preset to run true under a condition of no load, it is
important to check alignment and make adjustments if required during the initial
few minutes of loaded operation. To adjust alignment, see Section 8.3.5.
Conveyor Belt Alignment on page 31.
8.1.2. 8 H
OURS OR
D
AILY
A
LL
M
ODELS
• Check the conveyor belt tension and alignment (See Section 8.3.3.).
E
LECTRIC
D
RIVE
M
ODELS
• Check drive belt tension and alignment.
H
YDRAULIC
D
RIVE
M
ODELS
• Check hoses for wear.
8.1.3. 40 H
OURS OR
W
EEKLY
• Check the conveying belt tension and alignment (See Section 8.3.3.).
• Check condition of hopper flashing. Be sure it seals the hopper and pre-
vents grain leakage.
• If equipped, look for hydraulic leaks and repair if required.
8.1.4. 200 H
OURS OR
A
NNUALLY
• Check tire pressure and add air if required. Inflation pressure details can
be found on the tire itself.
• Check roller bearings for wear. Any rollers making noise, getting hot while
running, or that have play should be replaced.
• Repack wheel bearings.
• Wash machine.
• Inspect roller lagging to see if it is showing signs of wear.
Warning: Before continuing, please reread the safety information relevant to this section at
the beginning of this manual. Failure to follow the safety instructions can result in serious
injury, death, or property damage.