Batco 1300 P Series, Руководство по эксплуатации

Страница: 33 / 44

BATCO - T
OP
D
RIVE
F
IELD
L
OADER
8. M
AINTENANCE
1300 P, 1500 P S
ERIES
8.3. S
ERVICE
& M
AINTENANCE
P
ROCEDURES
P1512121 31
Figure 8.1 Pinch Top Drive
8.3.5. C
ONVEYOR
B
ELT
A
LIGNMENT
If your belt is tracking to one side, use the instructions below and follow the steps
listed to center it. Follow the steps in the appropriate section(s) in order. If you
are unsure where the problem is, start at the beginning of this section and work
your way to the end. Skip sections that do not apply. The process can be lengthy
but will help ensure trouble-free operation and long belt life.
Important: Ensure that conveyor is empty of all product before adjusting belt alignment.
H
OPPER
R
OLLER
1. Loosen bearing bolts and jam nut (if equipped).
2. Rotate adjustment bolt 1/2 turn on the side the belt is running toward.
3. Restart conveyor and run empty for one minute.
4. Stop conveyor, remove ignition key or lock out power source.
5. If belt has centered, then move to next step below; otherwise, repeat from
step 2.
6. Tighten bearing bolts and jam nut (if equipped).
WARNING
Before aligning belt, remove ignition key and
lock out power.
After aligning belt, replace guards if removed.