Batavia 7061494, Руководство по эксплуатации

Страница: 25 / 64

2. Tighten the cutting depth limit stop knob
(9). The motor or respectively the saw
blade can now be pushed down to the set
cutting depth.
For a clean, safe cut set the cutting depth in
such way that only max. one saw blade
tooth protrudes under the work piece.
SET CUTTIng AnglE
The plunge saw can be swiveled between 0°
and 48°:
1. Loosen both rotary knobs (8). Swivel the
motor to the desired cutting angle on the
cutting angle scale.
2. Tighten the rotary knobs (8) again.
DETERmInE CUTTIng lInE
Two cutting lines are marked on the base plate
(4) of the plunge saw.
1. Align position
A (0 mark on base plate) at
the front of the base plate with your marked
25
EN
Change Saw Blade
Plunge Cut
Marked Cut
Only use saw blades with a minimum speed of
5500 rpm.
SWITCH PlUngE SAW On/OFF
1. Press the switch lock (1) and then the ON/
OFF switch (2) to switch the plunge saw on.
2. Release the ON/OFF switch (2) to switch
the plunge saw off.
notes: Pressing the switch lock (1) unlocks
the plunge cut mechanism at the same time,
so that the motor can be moved downwards.
The saw blade emerges from the protective
cover. When lifting the saw the motor slides
back into the initial position.
SET CUTTIng DEPTH
The cutting depth can be set between 0 - 54
mm:
1. Loosen the cutting depth limit stop knob (9)
and slide it to the desired cutting depth
according to the graduated scale (11) to set
the cutting depth.
note:
The graduated values on the scale
(11) apply for straight cuts (90° cut).
The guide rail track compensation (10)
must be tilted
up when using the plunge
saw without guide rail. Only when using
the plunge saw with guide rail the guide rail
track compensation is used to compensate
for the thickness of the guide rail.
Using the guide rail = guide rail track
compensation down.
Not using the guide rail = guide rail track
compensation lever up.