FEDERATION
wall mounted exposed bath set
F9365
Specifications
Installation Instructions
IMPORTANT INFORMATION, please read before starting installation.
CHECK 1
Before installation, please ensure that you have checked the assembly of all components and
joints.
CHECK 2
Always use plumbers tape or a recommended sealing compound on all threaded joints.
CHECK 3
Please pressure test the tapware prior to installation using recommended testing equipment.
CHECK 4
The installer is responsible for selecting the correct fittings and that the distances are correct
before installation.
Products in this specification manual must by regulation be installed by licensed and registered trade people.
Under our commitment to product development and improvement, we may change product specifications
and dimensions or delete models from the range without prior notification. Dimensions and set-outs listed
are correct at time of publication and could contain dimensions which are approximate due to tolerances in
manufacturing processes. It is important that you thoroughly review the product and check specifications
and dimensions prior to surface preparation, cut-out and installation.
During the installation of the product by a qualified trained personnel, make sure that the entire fastening
surface is even and smooth (no protruding seams or tile offset), that the finish of the wall is suitable to apply
the product and has no weak points. It is recommended that all accessories are secured to timber studs.
Disclaimer:
