The Noise
2
module consists of two boards. All the parts comes in three bags separated for Bottom
board, Top board and Assembly parts. See Bill of Materials (
) for detailed list.
Before starting this kit, prepare the following tools:
● Soldering iron (1520W)
● Multimeter
● Flush cutters
● n2. hex screwdriver or allen key (enclosed with kit)
● Phillips screwdriver (cross)
● Wrench No. 8
● Protective eyewear
We suggest that you work in a clean and a well lit and ventilated environment to avoid accidents or
losing any of the small components.
Also briefly go through this guide and make sure that you understand all the steps.
BOTTOM BOARD
Let’s start with the bottom board. Before you start soldering, take your time and find all the resistors
values
(or you can check the color codes if you are seasoned enough).
Now insert and solder 26
resistors
(13x 100k, 7x 1k, 2x 22k, 1x 270k, 1x 47k, 2x 470k). Then snip the
leads as close to the PCB as you can (be sure to make this step on all remaining leads in the course of
2
https://learn.sparkfun.com/tutorials/howtouseamultimeter/measuringresistance
2
