Bastl Instruments KASTLE v1.0, Инструкция по сборке

Страница: 3 / 16

BEFORE STARTING THE KIT...
Prepare the following tools:
● Soldering iron (15-20W)
● Flush cutters
● n2. hex screwdriver or allen key (enclosed with kit)
● Needlenose pliers
● Protective eyewear
We suggest to work in a clean and a well lit and ventilated environment to avoid accidents or losing any
of the small components.
Also briefly go through this guide and make sure that you understand all the steps.
SOLDERING
Start the soldering with the
​ resistors ​
. There are just
​ two ​ values
of them:
​ 1k
(11x) and
​ 100k
(9x).
Before you will start soldering, check the values by
​
using a multimeter or you can check the color codes 1
- the 100k's have the
​ orange ​ stripe ​
. Then snip the leads close to the PCB (be sure to make this step on
all remaining leads in the course of this guide) and
​ set aside a few of them ​
. You will use them later.
Solder also the
​ Zener diodes
(10x) -
​ be careful, diodes are polarized!
Make sure that the black
stripe on the diode matches the stripe on the PCB. See the photos below for all these steps.
1
​
https://learn.sparkfun.com/tutorials/how-to-use-a-multimeter/measuring-resistance
3