Signal and Speaker Connections
Signal input is by means of a pair of RCA connectors at the speaker output end of the amp.
There is also a helpful pair of RCA outputs, which mirror the inputs, to assist with onward
signal requirements.
Fit the remote control knob and route the cable to a convenient place.
The speaker outputs are mono, obviously, so you can use either or both of each polarity to
drive each woofer as required, or for bi-wiring in the case of a (big!) single coil single
woofer. The unit is rated to 1 ohm stable. Destroyed DB1.8’s that have been abused in
competition to extract the absolute maximum power possible from the unit by running at
less than 1 ohm of load are NOT covered under warranty. If you need more power, buy
more amplifiers. Don’t wreck the one you have and expect someone else to pay for it!
