
Camera Interface
BASLER A102
k
2-3
DRAFT
6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Figure 2-2:
A102
k
Pin Numbering
2.1.3 Connector Types
The 26 pin connector on the camera will be a female .050” MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera will be a Hirose micro-miniature locking receptacle (part #
HR10-7R-6PB) or the equivalent. The recommended mating connector is the Hirose micro-
miniature locking plug (part # HR10A-7P-6S). A Hirose locking plug will be shipped with each
camera. This plug should be used to terminate the cable on the power supply for the camera.
Pin
Number
Signal
Name
Direction
Level
Function
1, 2
[1]
12 V In
Input
+12 VDC
Camera Power Input
3
Not Connected
4
Not Connected
5, 6
[2]
DC Gnd
Input
Ground
DC Ground
[1]
Pins 1 and 2 are tied together inside of the camera.
[2]
Pins 5 and 6 are tied together inside of the camera.
Table 2-2:
A102
k
Pin Assignments for the 6-pin Micro-miniature Receptacle
3
4
1
2
5
6
1
13
14
26
Содержание A102K
