background image

12. SeRViCe

 

CAUTION!

Servicing the SaniDry XP with its high-pressure refrigerant 
system and high-voltage circuitry presents a health hazard 
which could result in death, serious bodily injury, and/or 
property damage. only qualified service people should service 
this unit.

12.1 Warranty

A warranty certificate has been enclosed with this unit. Read 
it before any repair is initiated. If a warranty repair is required, 
call the factory first at 1-800-640-1500 for warranty claim 
authorization and technical assistance.

12.2 Technical Description

The SaniDry XP uses a refrigeration system similar to an air 
conditioner’s to remove heat and moisture from incoming air and 
add heat to the air that is discharged (see Figure 1).

Hot, high-pressure refrigerant gas is routed from the compressor 

to the condenser coil (see Figure 1). The refrigerant is cooled 
and condensed by giving up its heat to the air that is about to be 
discharged from the unit. The refrigerant liquid then passes through 
a filter/drier and capillary tubing, which cause the refrigerant 
pressure and temperature to drop. It next enters the evaporator coil 
where it absorbs heat from the incoming air and evaporates 

The evaporator operates in a flooded condition, which means that 
all the evaporator tubes contain liquid refrigerant during normal 
operation. A flooded evaporator should maintain constant pressure 
and temperature across the entire coil, from inlet to outlet. 

The mixture of gas and liquid refrigerant enter the accumulator 
after leaving the evaporator coil. The accumulator prevents any 
liquid refrigerant from reaching the compressor. The compressor 
evacuates the cool refrigerant gas from the accumulator and 
compresses it to a high pressure and temperature gas to repeat 
the process.

13. ConDenSaTe PUMP

The Condensate is automatically pumped to a remote location when 
the water level in the pump’s reservoir rises to close the float switch.

SaniDry XP INSTALLER'S AND OWNER'S MANUAL

SaniDry XP WIRING DIAGRAM

figure 2: electrical Schematic of the SaniDry XP Dehumidifier

6

SaniDry XP Installer’s & Owner’s Manual

Содержание SD109 SaniDry XP












Отзывы: