1
800 362 8774 | hydropoint.com | [email protected]
Cloud Network Module
Installation and Configuration Guide
The Cloud Network Module is available for use
on the BaseStation 1000, the BaseStation 3200,
the FlowStation and the SubStation. It mounts
internally to the top of X-cabinet enclosures and
to the back plate of pedestal enclosures. Power is
supplied by the 5-pin connector, along with any
communication lines that are being used.
The Cloud Network Module provides multiple
communication channels that can be used
by controllers or other devices. The following
channels are currently available for use:
• Cloud Network Ethernet
• Cloud Network Wi-Fi
• Cloud Network Cellular
Materials Provided
• Cloud Network Module
• Antenna with cable
• 5-pin serial cable
• Zip Ties
Tools Needed
• Phillips screwdriver
• Crescent wrench
• Needle nose pliers
We recommend that you back up your current configuration before starting this process in case you
need to restore your system.
• Refer to Backing Up the Controller Programming in the BaseStation 1000 User Manual.
• Refer to Backing Up Your System in the BaseStation 3200 User Manual.
You will also need to halt all watering while you install the Cloud Network Module.
• BaseStation 1000: Press the OFF button.
• BaseStation 3200: Turn the dial to the OFF position.
Please ensure the firmware version of your Baseline controller
meeets the minimum required firmware version to ensure device
compatibility. Minimum required versions are as follows:
• BaseStation 3200 V17.12
• BaseStation 1000 V1.25
• FlowStation V3.5
• SubStation V2.3
