FWG09I Assembly instructions
12
Calling the FWG09 via telephone
You can also call the FWG09 with a normal telephone. A few seconds after the FWG has picked up it
sends an answer tone. After this tone you can enter commands via DTMF. The commands needed for
gate keeper mode are explained there on page 13.
The code transmitter known by FWG 85 and FWG 90 also works.
Call and setup of voice communication via telephone
If you know the object number, you can type in “*
<Object> <Car>
*” one after another after the
answer tone, so for example “*719171*” for the unit with the object number 71917 and car 1. Then
you can either terminate the voice communication with “*0#” or switch to the next car with
“*
<Car>
#”.
Control the service menu with a phone
In order to be able to configure a FWG09 mounted behind the elevator panel without opening the
panel, you can also access the service menu via DTMF. To do this, call the device and type in
“*
<Object>
<Car>
0*” after the answer tone, for example “*7191710*” for the device with object
number 71917 and car 1. The FWG09 responds with “
Service car
<Car>
”. Now you can use the service
menu with the buttons on the phone:
base app
The FWG09 can also be configured with tone sequences that are played in the car. There is a base
app for smartphones and an audio file that serves as a key. Before using the base app, the audio file
must be played in the car. The FWG09 then announces its object number and other information.
Now you can start the base app and use it for configuration and testing. For more information please
contact base engineering gmbh.
1 Button Menu
2 Button
3 Button Option-
4 Service menu On/Off
5 Alarm / Emergency Over
9 Reset, the FWG disconnects
1
Menu
2
3
Option-
4
Service
On/Off
5
Alarm
Emergency Over
6
7
8
9
Reset
*
0
#
