Base aire AirWerx 90X, Руководство по установке и эксплуатации

Страница: 7 / 16

5
.
Manual Drain Button
·
For extended storage or movement of the machine, press the "Drain" button to remove water
from the integral pump’s reservoir.
6
.
Pump Trouble Warning
·
When the pump reservoir water level is too high, the high water sensor will activate to prevent
overflow. When this occurs, the dehumidifier will stop the compressor automatically and the display will
show "E4" error. After a 1 minute delay, the fan motor will turn off and the machine will not operate until
the problem is resolved. To reset the unit after an “E4" error, check the pump to verify it is functioning,
then unplug the unit for two minutes.
7
.
Auxillary Terminals A5
/
A6
·
The A5/A6 on the terminal strip can be used as a safety switch for external condensate pumps. It
should be set to N/O (normally open) at the dehumidifier. If an E4 error codes, switch the wiring to N/C
(normally closed).
5
Indicator Lights
1
.
Humidity Display Screen
·
The display screen has two functions
:
1
.
When the unit is powered on
,
it shows the humidity of the space
.
2
.
While setting the desired humidity level
,
the screen will show the set humidity
.
After a brief delay
,
the display will revert to the current humidity level
.
2
.
Power Indicator Light
·
This light indicates that the unit is properly powered on and ready to operate
.
Always make sure the is
"
off
"
prior to performing any service
.
3
.
Continuous Mode
/
AutoDefrost Light
·
When this light illuminates green
,
it indicates that the dehumidifier is set to continuous operation mode
.
·
When the light glows red
,
it means the unit is in auto defrost mode and clearing the evaporator coil of
any ice buildup
.