Base aire AirWerx 140X, Руководство по установке и эксплуатации

Страница: 5 / 20

3
Specifications
Capacity @ 80°F/60%RH: 140 Pints Per Day
Airflow: 440 CFM, 680 CMH
Operating Temp. Range: 33.8-110°F
Operating Relative Humidity Range: 35%-90%
COP: 2.75 L/kWh
Refrigerant: R410A
Amperage Usage: 8.3 Amps
Power Supply: 115V/60Hz/Single Phase
Outlet Requirement: 15 Amp
Sound Level: 60 dBa
Dimensions LxWxH: 33.9” x 18.1” x 19.3”in
ETL Listed: Yes
How It Works
Installation
1. Place dehumidifier on a level surface.
2. Set up the drain line
3. Plug dehumidifier into grounded 15 amp circuit.
AirWerx dehumidifiers use an integrated humidistat to monitor theconditioned space. When
the relative humidity goes above the selected setpoint, the dehumidifier will energize. Air is
then drawn across an evaporator coil, which is cooler than the dew point of air. This means
moisture will condense out of the air. The air is then reheated through the condenser coil and
distributed back into the room.
• Do not place unit directly on vapor barrier. For example, use blocks or pavers to create a
level surface.
• If unit has been turned or flipped so that the compressor did not remain upright, place the
unit on a level surface and wait a minimum of 2 hours before proceeding.
• Locate the dehumidifier near a suitable drain (6' drain hoseincluded). Allow for proper
drainage and routing of needed drain pipes
• Connect the drain pipe to the quick connector of the dehumidifier before placing the drain
pipe into the sewer
• The dehumidifier is equipped with a built-in drainage pump to support the drainage height
of 18 '.