- 28 -
If the device is mounted in workshops or garages in which flammable or combustible
lacquers are used, keep a safe distance of at least
4 meters
from the source of
hazard.
If the device is installed in the areas in which spray-painting of any type is
performed, it cannot be switched on during lacquering.
Mount the device so that the plug is easily accessible so as to quickly disconnect
the device from the power supply if the need arises.
Installation
The device is designed for wall mounting. Use the supplied mounting accessories.
Perform the following actions:
Step 1:
Using the holes in the wall holder or data
on the above drawing, mark 4 drilling
places at the height of at least 180 cm.
Drill 4 holes and insert 4 supplied M6*50
anchors.
Step 2:
Unscrew the nuts by means of the
open end wrench, then remove spring
washers and ordinary washers from
threaded bolts. The removed elements
will be used in the next step.
Step 3:
Mount the wall holder of the heater on the
threaded bolts of the anchors. Place the
washers on the threaded bolts and tighten
the wall holder with the nuts.
The heater was mounted on the wall
and will be used as needed.
Wall
Wall
Wall
