- 22 -
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
5.2 Installation and connection
•
Before first use, clean the device (filter basket, standpipe, lid and the inside of the water tank)
with a mild soap solution and rinse it with clear water.
CAUTION!
Do not dunk the bottom of the device into water!
•
In order to remove manufacturing greases from the standpipe use a bottle brush and a warm
soap solution. Wipe it with a soft, dry cloth.
•
Insert the standpipe in the hole of the filter basket when assembling.
•
Place the device on top of an even and safe surface which supports the weight of the device
and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as: table cloth,
carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Position the device in a way so that the power plug is always accessible.
5.3 Operating
Brewing coffee
•
Fill the reservoir with cold water (check the level indicator to see how much)
•
Make sure to use the minimum amount of coffee for brewing, which is:
for device A190.142
→
15 cups
→ approx
. 2 liters
for device A190.192
→ 35
35
35
35
cups
→ approx
. 5 liters
CAUTION!
Do not fill the coffee maker at levels higher than those indicated!
Never use warm water for brewing coffee!
•
Place the round paper filter into the filter basket.
NOTE!
Use only round paper filters in the coffee maker with a round filter.
We recommend using BARTSCHER round paper filters no. A190.009 for model Regina 40
(A190.142) and no. A190.011 for model Regina 90 (A190.192).
•
Put ground coffee (approx. 6 g per cup) in the filter basket. Set the filter basket in the heating
grate. Do not forcefully move the submersion tube.
