- 36 -
5.2 Installation
The device and the control unit are adjusted to the installation in the work table board.
During installation, follow these \instructions:
1. For installation, select a board of the work table that is heat resistant to avoid
deformation due to the device heat radiation.
2. Make sure that the thickness of the work table board complies with the load
requirements (at least 30 mm).
3. Cut the opening in the work table board according to the diagram below.
4. Provide sufficient ventilation around the device and make sure that the ventilation
holes are not blocked.
5. Hint: A secure distance between the hob and a cupboard above the device should be
at least 760 mm if no extractor hood is provided for.
