- 30 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device
only in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
Preparation of the device
•
Remove all equipment elements from the device and completely unwind the
power cable.
•
Rotate the temperature controller knob to position „OFF“.
•
Due to hygienic reasons clean the device with boiling water before the first use. Fill the
device with approx. 6 litres of water and connect the plug to the earthed socket. Boil
water for approx. 5 minutes with use of highest temperature setting „MAX“. Read
instructions on section „Heating liquids“.
•
Then rotate the knob to position „OFF“ and disconnect the device from the socket (pull
the plug!) and wait until it cools down. Then drain water from the tank and rinse it with
clean water, drain it again.
•
Clean the device according to instructions in section 6 „Cleaning and descaling“.
Heating liquids
•
Drinkable liquids must always be in the container before the device is turned on.
Do not pour undrinkable liquids such as acids, bases, oils, nitrates etc. into the
device!
•
The device is equipped with an overheating/dry heating protection function. If the
device is accidentally left on with too little or no water, this function will be activated
and the device will turn off automatically.
Turn the temperature dial to the „OFF“ position, remove the device’s plug from its
socket and wait at least 30 minutes for it to cool. After cooling, refill the tank with fresh
water and resume using the device normally.
