Bartscher Coffeeline 190.161, Инструкция по эксплуатации

Страница: 40 / 113

- 36 -
3. OFF
The device is disconnected from its power source.
Heating of liquids
•
Hold the steam arm (see (1) fig. 1) over the run-off tray and open the steam
regulator slightly in order to receive drops of water from the steam arm.
•
Turn the steam regulator.
•
Immerse the steam arm into the liquid which is to be heated.
•
Open the steam regulator. The liquid is now being heated (never remove the steam
arm from the liquid if the steam regulator is open, as this may cause burns or
damage). Prior to removing the steam arm, close the steam regulator.
•
When the heating process finishes, keep the steam arm above the run-off tray and
open the steam regulator in order to clean the steam arm. Close the steam
regulator and wipe the steam arm with a moist cloth.
Hot water
•
Place a container under the hot water spout from which you wish to draw water.
•
Open the water regulator (see (4) fig. 1) until the desired amount of water is obtained.
•
Close the water regulator again.
•
Check the run-off tray regularly.
Programming water doses for tea
Hold the “Continuous function button” for over 8 seconds of any of the brewing assemblies.
The program’s current setting is displayed by the LED displays of a given brewing
assembly (besides the LED “continuous function button” – which flashes). The display
shows the following information:
OFF
ON
Fig. 5
Doses programming
select 30s