Bartscher 8L MDI, Оригинальное руководство пользователя

Страница: 15 / 22

Installation and operation
132265 13 / 20
EN
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• Do not use the appliance with an external timer or remote control.
5.2 Operation
Warning Indications
• Ins ert t he bott om c over in the applianc e. The c over acts as a spac er bet ween t he heating element and l ef t-over f ood tray.
Caref ull y put t he c onnecti on box wi th the heating element on t he bac k edge of t he appli ance. T he pi n in t he connec tion box lower par t must enter t he hole in the main appliance. T his way t he c onnecti on box is pr operl y mount ed.
WARNING
Risk of scalding arms, hands, and fingers by escaping steam.
Use the handle to gently remove the lid from the basin.
To remove the pasta basket, use the handle only.
Use protective mitts to remove the lid and the pasta basket with food.
Risk of scalding arms, hands, and fingers by hot steam.
Never reach inside the basin during or immediately after operation. Before
emptying the basin, make sure the water is chill; to this end, hold your
palm 2
–5 cm above the basin.
Appliance Preparation
1. Remove the pasta basket from the appliance.
2. Fix the handle to the pasta basket, hooking it on the fixing element, tilting back
and sliding onto the basket support and clicking in place.
3. Remove the control box with the heating element and permanently fixed cover
from the appliance by pulling it out of fastening element and upwards.
4. Remove the basin from the appliance using removable holders.
5. Before use, thoroughly clean the appliance and equipment according to
instructions in section 6 'Cleaning' .
6. Dry all washed elements and surfaces thoroughly.
7. Place the chamber in the appliance housing.