Installation and operation
150184
13 / 18
EN
1. Make sure that the juicer is assembled completely and correctly.
2. Prepare the vegetables and fruit; if needed, slice them into suitable chunks that
will fit the juicer's hopper better.
3. Plug the appliance into a suitable single socket.
4. Use the rocker switch to select one of the speed levels:
– top
'1'
position of the switch is for high speed;
– top
'2'
position of the switch is for low speed;
– OFF
'0'
position is for switching the appliance off.
To obtain better results, use the
'2'
position for processing fruit and vegetable into
juice.
5. After selection of the speed level, fill the hopper with selected fruit or vegetables
and push them down with the pusher (2).
WARNING! Injury hazard!
Never push the fruit nor vegetables with your fingers nor kitchen utensils.
To this end, always use the designated pusher!
6. To squeeze the juice better, press the pusher down slowly.
7. Make sure that during squeezing, the plastic beaker (4) or any other container is
under the outlet.
The squeezed fruit or vegetable juice flows out of the outlet in the sieve base (11)
and is collected in the juice container.
The left-overs are collected in the dregs container (1).
CAUTION!
If the dregs container is overfilled, it may damage the appliance.
Observe the condition of the dregs container and empty it regularly!
8. When the dregs container (1) is full, switch the appliance off with the rocker
switch set to OFF
'0'
position.
9. Empty the dregs container (1) in order not to block the motor.
CAUTION!
The appliance may not operate continuously more than 1 minute at a time.
10. If this is a too short a time to prepare the juice, switching the appliance off and
leave it to cool down before you continue the squeezing process.
Содержание 700 Series
Страница 1: ...700 150184...
