Bartscher 700 GN211, Руководство пользователя

Страница: 26 / 28

Possible Malfunctions
24 / 26 700415
EN
Error Possible Cause Solution
Temperature inside
the appliance is too
high / too low
Too little clearance between
objects inside the appliance Provide for sufficient
clearance between objects
inside the appliance
Appliance is overloaded Reduce the number of stored
objects
Incorrectly set temperature
controller Set the temperature control
correctly
Noise level of the
appliance rises Appliance is not placed on
an even surface Place the appliance on an
even surface
Loose nuts/screws Tighten nuts/screws
Appliance touches walls or
other objects Keep sufficient clearance
from walls or other objects
Objects in the appliance in
contact with each other Provide for sufficient
clearance between objects
Alarms and prompts
In the case of the alarm, the proper prompt flashes on the digital display,
interchangeably with the temperature value; also, the buzzer and the alarm replay
(if available) may be activated.
All alarms go off automatically (i.e. alarm prompt is stopped, when the cause for the
alarm is eliminated; only the 'CHt' alarm must be confirmed manually through
switching off and on again of the appliance with the use of button or
disconnection from the mains supply).
When pressed, the button switches off the buzzer; but the displayed alarm
code and the alarm relay are deactivated only when the cause of the alarm is
eliminated. The available alarm codes are listed in Table 3 below.
Alarm
Code Buzzer and
Alarm Relay LED Description RESET
E0 Active ON Sensor 1 error =
regulation Automatically
E1 Inactive ON Sensor 2 error =
defrosting Automatically
E2 Inactive ON Sensor 3 error =
condenser / product Automatically