- 30 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Connect the device only to properly installed single
socket with protective terminal.
Before the first use, the cooling display should be installed and left standing for at
least 2 hours before it is connected to the power supply.
After a power failure or removal of the plug, do not reconnect the device to the
power supply for at least 5 minutes.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
Preparation
Before the first start-up of the device use this manual to become familiarized with
the device and its equipment.
Before the device operation clean the device and its equipment according to the
instructions in section
6 “Cleaning”
.
Connect the device to the single grounded socket.Turn the device on with use of
switch located on the operation side. The indicator integrated with the switch will
come on.
The digital display will show the preset temperature value and the LED cooling
indicator will come on.
The cooling display may be filled with food products only when it reaches the sufficient
cooling power. Follow the instructions in section
“Cooling of food products“
.
