Possible Malfunctions
105760
23 / 24
EN
7
Possible Malfunctions
Mögliche
The table below contains descriptions of possible causes and solutions to
malfunctions or errors during operation of the appliance. When malfunction cannot
be removed, contact the technical service.
In such a case, provide article number, model name and serial number. These data
may be found in the rating plate.
Error code
Cause
Solution
E0
No cookware on the hob or
inappropriate cookware
Use only suitable cookware
E1
Appliance is getting too hot
(e.g. due to obstructed
ventilation openings)
Clear the air vents
Leave the appliance to cool down,
and then re-start
If the error code is still shown in the
digital display, contact the service
company
E2
(for Article
No. 105760 /
105762)
Defective temperature
sensor (it is active for about
1 minute and then the code
E2 is displayed)
Contact the service company
E2
(for Article
No. 105761 /
105763)
The overheating protection
has been tripped and the
device will switch off.
Disconnect the appliance from
mains power supply. Remove the
cookware from the hob.
Leave the appliance to cool down,
and then re-start
Defective temperature
sensor (it is active for about
1 minute and then the code
E2 is displayed)
Remove the cookware from the
hob.
Wait for the device to cool down
E3
Short lasting power cut
Disconnect the appliance from
mains power supply. After a few
minutes, plug the appliance in
again.
Have an electrician to check the
electrical connection.
Содержание 2P 35-1 TCK
Страница 1: ...2P 35 1 TCK 2P 50 1 TCK 105760 105761...
