Pag. 12
3.1 ROUTINE MAINTENANCE
3.
CLEANING AND MAINTENANCE
2.
OPERATING INSTRUCTIONS
2.2 SETTINGS
LIGHTING BURNERS
- Open main gas tap upstream of appliance.
- Press knob and turn from “
closed
” position to “
light/pilot light”
position
and at the same time press the pie-
zoelectric button until the pilot light comes on. The pilot light can be monitored through the inspection hole on
the control panel.
When first starting up, in order to keep the pilot light ON, keep the knob pressed for about 10 seconds. When
it is released, the pilot light should remain lighted, otherwise, repeat the operation.
- To switch on the main pilot light, turn the gas knob from the “
light/pilot light”
position
to the
“
maximum flame”
position.Adjust the temperature by turning the knob from position 1 to position 7.
SWITCH-OFF
- To switch off the main burner and then the pilot light, turn the gas knob to “
light/pilot light”
and then to
“clo-
sed”
.
- At the end of the working day, switch off the gas check valve upstream of the appliance.
The control knobs of the burner taps have two positions:
shut
lighting / pilot light
The appliance must be used only for the purpose for which it was designed. Any other use is improper.
During operation, supervise the appliance.
2.1 STARTING UP FOR THE FIRST TIME
Before starting up the appliance for the first time remove all the packing and thoroughly clean the protective
industrial grease from the appliance using water and normal detergent.
BIMETAL PLATE - INSTRUCTIONS FOR USE
When the plate is warm, dampen very slightly with vegetable oil and wait until the plate reaches the desired tem-
perature. For best cooking results, the temperature should be about 240°C - 250°C. The food may be cooked
on the entire surface of the plate.
At the end of the working day, clean the appliance, both for reasons of hygiene and to prevent operating faults.
Do not clean the appliance with direct or high-pressure jets of water and do not use metal pads, brushes or scra
-
pers in normal steel. If necessary, use stainless steel pads, but do not rub them against the grain of the metal
