DFG280 FLOOR GRINDER
OWNER’S MANUAL AND PARTS BOOK
9
OIPB
– S30004
OPERATING SAFETY PRECAUTIONS
The floor grinders are constructed according to existing safety rules and regulations.
These technical precautions should not be removed or changed under any circumstances.
While operating the machines the following points should also be kept in mind:
The instructions provided in this manual are done so to ensure the operator’s safety as well
as that of others, the equipment, and the job site. Failure to follow these guidelines can lead to
serious personal injury and even death. The operator and any service personnel should read
and understand the entire manual before working with or servicing any SPE Floor Grinder.
•
The grinders should always be operated with all safety covers and technical precautions.
•
During transport, cleaning, repair or maintenance the grinder must be disconnected from
the power supply. That also applies to the changing of tools.
•
The safety ring can only be removed while operating the machine directly against the
wall. While operating the machine without the safety ring dust can be generated. In this
case the operator must wear a mask. In all other cases the grinder must be operated
with the safety ring.
•
The operator should never leave the machine unattended during operation.
•
Before leaving the machine, all rotary parts should be brought to a standstill. Electric
models must be disconnected from the power supply. Make sure that the machine cannot
roll or move by itself.
•
After any maintenance and adjustment all safety covers must be reattached.
•
Ear protectors must be worn.
•
Eye protectors must be worn.
•
Safety shoes with steel caps must be worn.
•
In the event of a large amount of dust during operation, connect a dust collector to the
grinder.
•
Depending on the floor (floor coating) grinding can produce gases. The operator must be
held responsible if these generated gases are dangerous and if protection is necessary.
Grinding floors containing asbestos is especially dangerous and can cause health
problems. Special masks must be worn which keep the breathing air clean. A dust collector
must be used and should be equipped with filters suitable for asbestos dust.
•
The floor must be brushed before grinding because loose material could get into the tools
and fly away. Anchor screws and bolts coming out of the floor can also be seen better if
the floor is clean. If the grinding head hits a anchor screw or bolt then serious damage can
be caused to the machine or grinding head.
Содержание SPE DFG280
