P a g e
|
13
OIPB-I01029-Infinity2.0_v1.2
•
To adjust the jaw assembly down, push and hold jaw lever forward. To adjust the jaw
assembly up, pull and hold the jaw lever back.
2. Auto Stop
When you release the drive or jaw lever, the motor continues to run but the drive or jaw
motion automatically stops and will not start again until you push or pull the levers.
3. Emergency Brake
The Terminator
®
is supplied with an emergency brake to prevent unintended movement
when left unattended. The brake handle is located to the left of the operator seat. Pull
the handle up to engage the brake, push the handle down to release the brake. To
increase tension on the brake you can rotate the end of the handle in a clockwise
direction. Rotate the end of the handle counter clockwise to reduce the tension.
14. Display & Indicators
1. Battery/Hour Meter
The battery/hour meter displays battery life, run-time, and current voltage. At 30%
battery life, the light will turn yellow. At 10% battery life, the light will be red, indicating
very low battery levels and the need to charge. The text display will normally show total
hours to one decimal place, and an alternate mode will display the current voltage to
two decimal places. Please contact your service provider when changing the settings of
your battery/hour meter.
2. Emergency Stop
In case of emergency push down the red emergency button on the right side of the seat
platform to remove power from all electrical components. To restore power, turn the
button to the right and it will return to its original position.
15. Electric Motor & Batteries
The electric motor and batteries are located under the top cover. The electric motor
provides the power to the hydraulic pump to drive the Terminator
®
. The electric motor
requires little maintenance, inspect wire connections and check for debris to maintain its
efficiency and prolong its operating life.
16. Blade Assembly
Blades are available in different configurations and thickness. An assortment of blades is
included in the purchase price of the Terminator
®
. Extra blades are available upon request
from Innovatech Products & Equipment Co., Inc.
Installing a Blade:
1.
Raise the jaw assembly to maximum up position.
2.
Unwrap the pre-sharpened blades and select the blade thickness and length you
need for the job.
3.
Loosen the 7 holding bolts.