FINISH OF CUT
1. Bring the blade out of the
cut
by method explained under
"
To Maneuver Saw
"
.
Raise blade high enough to clear the pavement when maneuvering the saw.
2. Turn off water valve.
3.
Close engine throttle to idle pos
ition.
Let engine
cool down
before
stopping.
4. Do not leave
the saw
until the blade and
saw
has
completely stopped.
MAINTENANCE INSTRUCTIONS
1. Lubricate blade shaft bearings daily! Note: When
cutting
dry grease blade
shaft
bearings two or
three
times daily.
Grease
provides
an
added protective
seal
for the
bearings. Use only
a
premium lithium-based grease
conforming
to NLGI No.2
consistency.
After
a
maximum of every 40 hours of operation grease
front axle pivot
bearings
and
grease depth control adjustment shaft.
2.
Check engine oil daily. Keep oil
clean
and
at
proper level. Since the engine often
operates
at an
angle
check
the
oi
l
level (with
engine
horizontal)
frequently to
ensure
that
the
oil
level never falls below the lower mark
in the
dipstick
.
Follow engine
manufacturer
'
s
recommendation
on changing
oil.
3.
Clean engine air filter. When
cutting
dry
clean air
cleaner two or three time
s
a
day.
See
engine
manufactures manual for
proper care an
d maintenance.
4
.
Engine care:
See engine manual.
5. Blade shaft V-belts tension: This model concrete saw is equipped with 3VX
premium V-belts.These belts are properly
tensioned
at the factory. Severe damage
or even breakage of the crankshaft might occur if the belts are tensioned too tight.
Check belt tension as
set
on the new saw and never setbelts beyond original
fac
tory tens
ion. Not enough tension will result in poor saw performance and short
belt life
.
Belts should never be allowed to slip. After two hours of use re-tension
belts to make up
for
init
ial
stretch.T
o
re-tension the belts turn engine off. Loosen
the four bolts
holding
the engine. Turn
the
horizontal
tensioning
bolt on the left rear
of the saw frame clockwise until the belts are tight.Re-tighten the four bolts on the
engine.
Continue
to
check
the
belt
tensio
n on
a regular basis and
re
-t
ighten
as
necessa
ry.
To obtain
accu
rate
V-belt setting a V-belt
tension
tester
shoul
d
be used. Check
the
setting on a single belt of a
mat
ched
set
of V
-be
lts.
Apply
load
at
the
center of the
belt span.
De
flec
tion
should be 3/16" with a 5 to 6 Ib. load.
STREET SAW INSTRUCTION MANUAL
375 ANNAGEM BLVD., MISSISSAUGA, ONTARIO, CANADA L5T 3A7, 905-364-4200 FAX 905-364-4201
6