Bartec TC78ex-NI, Быстрый старт

Страница: 47 / 60

TC78
ex
-NI - Touch Computer
Type B7-A2D*-****/********
Operation
Subject to technical changes.
October 2023
41/52
Change battery - work steps:
The device provides a Hot Swap mode where you can replace the battery without
powering off the device. Replace the battery within maximum one minute. After one
minute, the device reboots and data may be lost.
For detailed information about the hot swap function, please refer to the TC78 Touch
Computer - Product Reference Guide (EN) from ZEBRA.
Chapter: Replacing the Battery --- Battery True Hot Swap
ATTENTION
Incorrect handling may cause damage to property!

Use only batteries which have been tested or certified by BARTEC for this
purpose.

If the battery change takes longer than 1 minute, switch off the TC78
ex
-NI with
function "Power Off" before removing the battery. Mistakes when removing the
battery can cause data loss.

After replacing the battery, wait 15 minutes before using Battery Swap again.

The persistence durations of 30 seconds for Wi-Fi/WAN and 60 seconds for
storage are maximum values. These durations may be shortened depending on
application usage, network considerations, and device hardware capabilities.
1. Remove any accessory attached to the device.
2. Press the Power button until the menu appears.
3. Touch Battery Swap.
4. Follow the on-screen instructions.
5. Wait for the red LED to completely turn off.
6. Press the two battery latches in.