Bartec 07-7331-2301/0000, Руководство по эксплуатации

Страница: 14 / 24

01
-73
31
-7D
000
8/
V
er
sion:
06
th
of
Jun
e
2019
/ 405
495
Operation Instruction (Translation)
MODEX
Regulating and control components
PROFIBUS-Interface 16 x digital out Typ 07-7331-2301/0000
PROFIBUS-Interface 16 x digital in Typ 07-7331-2302/0000
EN
GmbH
Max-Eyth-Straße 16
97980 Bad Mergentheim
GERMANY
Phone.:+49 7931 597-0
Fax: +49 7931 597-119
info@bartec.de
www.bartec.de
Reservation: Technical data subject to change without notice.
Changes, errors and misprints may not be used as
a basis for any claim for damages.
2/22
2. Explosion protection and approvals
Regulating and control components
type 07-7331-…./….
ATEX
Test certificate PTB 97 ATEX 1066 U
Ex protection type
II 2 G Ex db e IIC Gb
I M2 Ex db e I Mb
IECEx
Test certificate PTB 11.0082U
Ex protection type Ex db e IIC Gb
Ex db e I Mb
Special conditions
(1) The regulating and control components must be installed in an
enclosure which corresponds to the requirements of a
recognised class of protection in accordance with
EN 60 079-0, Section 1.2.
(2) When installing in an enclosure with an increased
safety class of protection “e” in accordance with
EN 60079-7:2007, the clearance and creep age distances set
out under Section 4.3, Section 4.4 and Table 1 must be
complied with.
(3) The component can be used in Group I and II because the
requirements of the standard are identical in this case.
CSA
Test certificate 2011-2484303U
INMETRO
Test certificate UL-BR 13.0397U
Customs Union Russia (EAC)
Test certificate RU C-DE.BH02.B.00005
Further certificates
www.bartec.de
EU Conformity
ATEX Directive 2011/65/EU
EMC Directive 2014/30/EU 2014/30/EU
RoHS Directive 2011/65/EU
Product labelling 0044
3. Safety Instructions
Designated use
The control and regulating components may only be operated in a
clean, undamaged condition and is admitted only for a proper and
designated use. With infringement any guarantee and
manufacturer`s responsibility goes out.
The correct laws, norms and directives for use or project engineering
must be kept.
The assembly/dismantling of the regulating and control components
must be conducted by qualified personnel authorised and trained to
install electrical components in potentially explosive areas. The user
manual should be read and have been understood. The
responsibility for the assembly/dismantling, installation, service and
the operation lies carries the operator.
Danger, Warning and Note Symbols
Safety instructions and warnings are specially highlighted in these
operating instructions and marked by symbols.
DANGER
The DANGER sign draws attention to a direct threat which if not
avoided will lead to death or very serious injuries.
WARNING
WARNING draws attention to a possible threat which if not avoided
can lead to death or very serious injuries.
CAUTION
CAUTION draws attention to a possible danger which if not avoided
can lead to slight or minor injuries.
ATTENTION
ATTENTION draws attention to a potentially damaging situation
which if not avoided can cause damage to the equipment or to
objects in its vicinity
Important instructions and information on effective,
economical & environmentally compatible handling.