6
7
3. Loosen the middle stem’s lock nut in the direction of the arrow. Then, insert the
lower stem into the middle stem. Turn the stem’s lock nut in the reverse
direction of the arrow to lock it in place.
4. Unscrew the bolt of the control box and hitch the control box to the top stem.
Then, insert the bolt into the assembly hole on top stem and tighten it with the box.
5. Wind the cable around the stem. Insert the search coil cable plug into the five pin
jack at the bottom of control box’s housing.
Caution:
• The search coil cable plug fits into the connector only one way.
• DO NOT force the plug or you could damage it.
• DO NOT disassemble the stem lock nut.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end; adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough
to keep the search coil from rotating or wobbling.
INSTALLING BATTERY
You need two 9V alkaline batteries to power your detector.
1. If the detector is on, turn the power switch (on the control panel) to POWER OFF.
2. Press on the battery compartment cover and slide the cover off in the direction of
the arrow.
3. Connect the battery with the battery connector taking care of the polarity. Then put
the battery into the compartment.
4. Replace the cover.
Cautions:
• Use only fresh batteries of the required size and recommended type.
• Always remove old or weak batteries; batteries can leak chemicals that can destroy
electronic parts.
• If you do not plan to use the detector for a long time, remove the batteries.
• Dispose of old batteries promptly and properly.
• You can extend battery life by using earphones, which require less power than the
built-in speakers.
Headphones
1. It is recommended to choose the headphones with volume control.
2. Insert the headphones’ 3.5mm plug into the PHONE jack. At this time the internal
speaker disconnects.
3. Set the VOLUME to the desired setting.
