RDG603A11 - Issue 10 - Shire 14 85, 130 WB Owners
Manual Page 29 of 52
23. Installation Check list
Please tick box
Engine alignment correct, clearance all round, check propeller turns by
hand (Ensure ignition is off battery and battery master switch is off)
Anti-Vibration mounts correct height, spacers if necessary.
Make sure all nuts are tight
Exhaust system as specified
Battery leads are of correct size, tightened and start battery is charged
Check tension of alternator belts, wiring connected and belt alignment
checked If removed
Check fuel system is connected correctly and primed
Fuel line water trap installed and water drained off
Check header tank and skin tank connections are correct way round,
constant pipework rise to header tank
Check level of coolant in header tank and correct ratio of antifreeze to
water
All air has been bled from skin tank, calorifier and pipework
Engine and gearbox oil levels are as specified
Throttle and gear cables correctly adjusted and operating smoothly
All pipework and cabling supported and not chaffing, slack to allow
movement of engine
Confirm engine control panel, gauges and warning lights are all
operational
Run the engine for 20 minutes with the boat tied up and in gear (at ½
speed). Check for leaks and that all systems operate correctly
Check & Set the Engine Idle Speed to 850-875 rpm
Check for leaks
Explain/Demonstrate daily/weekly/periodic maintenance checks
Explain/Demonstrate off season storage and maintenance
If Applicable: Travel Power 230v AC systems installed by qualified
electrician and to BMEA code of practice for Electrical and Electronic
installation in Boats: BS EN ISO 13297 (ac)
Installer’s signature
Installer name/company
