Surface/Pole Mounting
Slip-Fitter
1. Connect wires from AXL2 to supply (see
Wiring
section) and
position wires inside pole (Fig. 7)
2. Secure slip-fitter over pole and tighten.
3. To position, loosen the adjustment bolt using a hex wrench
(provided by others), position head as desired, then retighten
the bolt.
Notice:
Adjustable angle is 0-90° (Fig. 7).
Arm
1. Disassemble the pole bracket from the arm.
2. If assembling to a round pole, remove and discard the adapter
gasket.
3. Using the pole bracket as a guide, drill holes in pole at desired
location.
4. Attach arm to pole with pole bracket inside pole.
5. Feed wire leads from the ALX2 through slot in arm.
6. Attach the AXL2 head to arm using adjustment bolt.
7. Adjust head to desired position and tighten adjustment bolt.
8. Wiring can be made inside the arm wiring compartment or inside
pole (see
Wiring
section).
9. Secure wiring cover to arm with gasket in between (Fig. 8)
Trunnion
1. Drill hole in mounting surface or rectangular pole.
2. Attach luminaire to mounting surface or retangular pole (Fig. 9).
3. Make supply connection in waterproof J-box or inside pole
(see
Wiring
section).
INSTALLATION INSTRUCTIONS
800.533.3948 • www.barronltg.com
Adjustment Bolt
Pole, round or rectangular
Slip Fitter
Pole
Bracket
Adapter
Gasket
Adjustment Bolt
Wiring Cover
Arm
Mounting surface
or rectangular pole
Fig. 7
Fig. 8
Fig. 9
20070138 REV 1 - 2/19
AXL2 (80-280W)
3
