Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
TPXC Series
Installation Instructions
XXXXXXXX R
EV 1 - 07/23
2
800-533-3948 www.barronltg.com
Wall Mount Installation (Fig. 2)
1. Open front cover by blade of screwdriver. (Fig. 1)
2. Knock out center and appropriate mounting screw holes on the
back plate.
3. Remove side hole plug from housing, snap lamp heads on the unit
and connect to PC board (Fig. 5)
4. Route the AC supply wires through center hole inside of housing.
5. Install fixture on the J-Box.
6. Make correct electrical connections inside of fixture according to
wiring diagram (Fig. 6)
7. Push excess wire into J-Box.
8. Snap chevron to EXIT panel if required.
9. Attach battery connector to PC board, restore front panel on unit,
adjust direction of lamp heads as needed.
Ceiling Mount Installation (Fig. 3)
1. Attach crossbar to junction box, set the crossbar so that the short
blade is touching the J-Box.
2. Open front cover by blade of screwdriver. (Fig. 1)
3. If double face is desired, replace back plate with additional face
plate provided.
4. Remove the mounting hole cover on the top and side of the unit,
assemble the canopy unit. (Fig. 4)
5. Snap lamp heads on the unit and connect to PC board. (Fig
. 5
)
6. Route the proper wires through the mounting hole out of housing.
7. Make electrical connections inside the J-Box according to wiring
diagram (Fig. 6)
8. Fasten crossbar on J-Box by screws provided, fasten canopy to
crossbar and against the wall.
9. Snap chevron to EXIT panel if required.
10. Attach battery connector to PC board, restore front panel on unit,
adjust direction of lap heads as needed.
